This throttle linkage kit has unique features not found on other products. It has unique
cable slack adjusters at both ends that allow you to fine tune the cable length to get
just the right amount of throttle opening. They also allow you to adjust the idle speed
on the grid without using a screw driver. They are not compression fittings so you can
remove the plastic cable housing and replace it as many times as you like.
Removing the engine is easy since it uses two of the existing mounting holes for the
black cover. Many other linkage kits require you to remove the black metal engine
cover to get at the nuts on the bottom side.
Just remove the two bolts , unscrew the slide nut on the carb and lay the entire
assembly in the seat.
It also has a unique cable splice that makes splicing the cables a snap.
Price $15.00 With black metal control cover $33.95
With Throttle cable, plastic cable housing and splice $19.95
prevent the throttle cable from sticking you can put a rubber boot over the end of
the rear slack adjuster
Just take the one that comes with the carb or fuel pump and put a small hole in it
for the cable to go through. Twist a piece of safety wire over it to hold it in position.
You can also use a plug for a vacuum fitting from the local auto parts store.
